Burner Flame - Amana LG4219*2 Service Manual

47. BURNER FLAME - Gas Models
a W A R N I N G
To reduce the risk of electric shock, fire, explosion, serious injury or death:
a. While supporting the lower access panel,
•Disconnect electric power to the dryer before servicing.
remove two screws from bottom edge of lower
•Close gas shut-off valve to gas dryer before servicing.
access panel, Figure 22.
•Never start the dryer with any guards/panels removed.
b. Gently lower the access panel to disengage
•Whenever ground wires are removed during servicing, these ground wires must be
guide lugs from bottom edge of front panel.
reconnected to ensure that the dryer is properly grounded.
c. Set timer at " 60" minutes.
d. Close the loading door, start the dryer in a
heat setting (refer to Operating Instructions
supplied with the dryer); the dryer will start,
the igniter will glow red and the main burner
will ignite.
e. Allow the dryer to operate for approximately
five minutes, then loosen the air shutter
lockscrew, Figure 48.
f. Turn the air shutter to the left to get a
luminous yellow tipped flame, then turn it back
slowly to the right to obtain a steady blue
flame.
g. After proper flame is obtained, tighten air
shutter lockscrew securely, Figure 48.
h. Reinstall lower front access panel and screws.
a W A R N I N G
To reduce the risk of fire or serious
injury, the access door must be in place
during normal operation.
After the dryer has operated for approximately three
minutes, exhaust air or exhaust pipe should be
warm.
Figure 48
47
W001
RS3200001 (502992R3)
Rev. 3