Amana LG4219*2 Service Manual page 25

a W A R N I N G
To reduce the risk of electric shock, fire, explosion, serious injury or death:
•Disconnect electric power to the dryer before servicing.
•Close gas shut-off valve to gas dryer before servicing.
•Never start the dryer with any guards/panels removed.
•Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
(1) Remove one screw from right side of
burner housing holding burner tube in
place, Figure 26.
(2) Gently move burner tube toward rear of
dryer to disengage tab from slot on left
side of burner housing, Figure 24.
(3) Carefully rotate burner tube and igniter
counterclockwise so tab is at 8 o' clock
position.
(4) Move air shutter end of burner tube slightly
to right and CAREFULLY remove burner
tube and igniter assembly out through front
of dryer.
(5) Remove screw holding igniter and bracket
to burner tube and remove igniter and
bracket, Figure 25.
IMPORTANT: Use care while removing igniter to
avoid damaging or breaking it. The igniter is
very fragile.
RS3200001 (502992R3)
Rev. 3
IMPORTANT: Handle igniter by grasping the
white ceramic portion of bracket only. DO NOT
handle silicon carbide portion of igniter with
hands or allow any oil, grease or other foreign
material to contaminate it. Oil, grease and other
impurities or hairline cracks will cause the
igniter to burn out.
c. Flame Sensor, Figure 24.
(1) While supporting the lower access panel,
remove two screws from bottom edge of
lower access panel, Figure 22.
(2) Gently lower the access panel to
disengage guide lugs from bottom edge of
front panel.
(3) Remove wires from sensor terminals,
Figure 24.
(4) Remove screw holding sensor to burner
housing, Figure 24.
Figure 25
24
W001