Cabinet Top - Amana LG4219*2 Service Manual

a W A R N I N G
To reduce the risk of electric shock, fire, explosion, serious injury or death:
•Disconnect electric power to the dryer before servicing.
•Close gas shut-off valve to gas dryer before servicing.
•Never start the dryer with any guards/panels removed.
•Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.

31. CABINET TOP

a. While supporting the lower access panel,
remove two screws from bottom edge of lower
access panel, Figure 22.
b. Gently lower the access panel to disengage
guide lugs from bottom edge of front panel.
c. Remove two screws holding bottom tabs on
front panel to dryer side panels, Figure 22.
Swing bottom of front panel away from dryer
far enough to disengage hold-down clips and
guide lugs from cabinet top.
d. Disconnect wires from door switch, Figure 21.
NOTE: Refer to appropriate wiring diagram when
rewiring switch.
RS3200001 (502992R3)
Rev. 3
e. Remove two cabinet top hold-down screws,
Figure 35.
f. Lift cabinet top to a vertical position by
hinging it on the rear top hinges, Figure 35.
NOTE: Cabinet top may be raised and hinged on
the rear hold-down hinges or supported against
wall behind dryer while servicing.
g. Carefully withdraw wire harness through hole
in cabinet top and lift the top off the top
hinges, Figure 35.
Figure 35
30
W001