Inner And Outer Door Panels And Door Pull; Loading Door - Amana LG4219*2 Service Manual

a W A R N I N G
To reduce the risk of electric shock, fire, explosion, serious injury or death:
•Disconnect electric power to the dryer before servicing.
•Close gas shut-off valve to gas dryer before servicing.
•Never start the dryer with any guards/panels removed.
•Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
15. INNER AND OUTER DOOR PANELS AND
DOOR PULL
a. Remove four screws holding door assembly to
hinges, Figure 9.
b. Remove screw from door pull, Figure 11, and
the remaining screws around the door
perimeter and separate panels, Figure 11.
NOTE: All screws are interchangeable except for
the screw in the recessed door pull.
REVERSING DOOR PROCEDURE
The door on this dryer is completely reversible.
Figure 10
Figure 12
RS3200001 (502992R3)
Rev. 3
IMPORTANT: Do not over-tighten screws when
reinstalling door pull.

16. LOADING DOOR

a. Open loading door.
b. Remove screws holding loading door to
hinges, Figure 9.
To reverse door proceed as follows:
16
Figure 11
Figure 13
W001