Storage; Disposal Of The Machine; Error Codes - Kemppi Kempact 251R Operating Manual

7.4

Storage

Store the unit in a clean and dry place. Shield it from rain, and in temperatures exceeding
+25 °C from direct exposure to sun.
7.5

Disposal of the machine

Do not dispose of electrical equipment with normal waste!
In observance of European Directive 2002/96/EC on waste electrical and electronic
equipment, and its implementation in accordance with national law, electrical equipment
that has reached the end of its life must be collected separately and taken to an appropriate
environmentally responsible recycling facility.
The owner of the equipment is obliged to deliver a decommissioned unit to a regional
collection centre, per the instructions of local authorities or a Kemppi representative. By
applying this European Directive you will improve the environment and human health.
8.

ERROR CODES

EN
Error 2: Mains under voltage
The machine has detected mains under voltage that disturbs welding. Check the quality of the
supply network.
Error 3: Mains over voltage
The machine has detected momentary voltage spikes or continuous overvoltage that can
damage the machine if allowed to continue. Check the quality of the supply network.
Error 4: Wire feed motor over current
Wire feed motor current is higher than the designed limit. Check condition of welding gun
contact tip, liner and wire feed mechanism.
Other error codes
The machine can display alternative codes not listed. In the event of an unlisted code
appearing, contact an authorised Kemppi service agent and report the error code shown.
34
Kempact 251R, 253R, 323R, 181A, 251A, 253A, 323A