Kemppi Kempact 251R Operating Manual page 25

12. Selection for filler wire diameter (adaptive mode)
WIRE Ø
When operating in adaptive mode and AUTOMATIC is selected from the mode selection
button 6, you can select from the filler wire diameter options. Following your materials
selection through button 11, press button 12 briefly to select the filler wire diameter. Not all
materials have alternative choices.
13. Selection for shielding gas or post gas function (adaptive mode)
GAS
POST GAS
When operating in adaptive mode and AUTOMATIC is selected from the mode selection
button 6, you can select from the shielding gas option for the filler material type set. Shielding
gas options are displayed with a short press of button 13. When operating in either MANUAL
or AUTOMATIC mode you can also select POST GAS function and make adjustments to the
POST GAS time value with adjustment knob 3. The POST GAS adjustment range is from 0.1
second to 3.0 seconds.
14. Selection of crater fill function (adaptive mode)
CRATER
FILL
When operating in adaptive mode and AUTOMATIC is selected from the mode selection
button 6, you can select CRATER FILL function. CRATER FILL function activates a pre‐set slope
timer at the end of the welding cycle and operates in either 2T or 4T gun switch mode when
the off signal is given.
15. Selection for memory function
MEMORY
1
2
3
4
SAVE
When operating in either MANUAL or AUTOMATIC mode, you can store your welding
parameters using the MEMORY function. There are four MEMORY locations to choose from,
and you can store either MANUAL or AUTOMATIC welding setup in any channel location. To
store your welding settings, simply press and hold a MEMORY button for 5 seconds.
To recall the welding settings for future use, simple short press the MEMORY buttons. To
record new weld settings to a channel, repeat the long press sequence.
© Kemppi Oy / 1135
EN
23