Welding Gun - Kemppi Kempact 251R Operating Manual

4. Cut away any deformed filler wire section and dress the sharp wire tip.
5. Connect the welding gun and tighten the collar.
6. Press the welding gun trigger and allow the filler wire to feed through the gun cable to
the contact tip.
Check once again that the filler wire is still properly seated in the grooves of both top and
bottom feed rolls.
4.5

Welding gun

EN
Connect the welding gun connector to the Euro adapter socket located below the wire feed
mechanism and hand tighten only. Do not over tighten the gun collar.
Remember to remove the sharp cut tip of the filler wire before loading the wire to the
NOTE!
welding gun, so preventing damage to the liner inside the welding gun cable. This is particularly
important for soft filler wires such as aluminium. It will also improve feed quality and increase the
service life of your gun liner.
12
Kempact 251R, 253R, 323R, 181A, 251A, 253A, 323A