Using The Autolink Feature - 3Com 09-0572-000 User Manual

3-4 C
HAPTER

Using the AutoLink Feature

Follow these steps to use the AutoLink feature:
1 Place the TokenDisk diskette in a floppy drive on your PC
and make that drive the active drive. For example, type:
A: [Enter]
2 Type at the prompt:
AUTOLINK [Enter]
The first time you use the TokenDisk diskette, the 3Com
software license appears.
3 To accept the terms and conditions of the 3Com end-user
software license agreement, type:
Y
To view the full text of the license agreement, press [F1].
A status message appears, followed by a prompt asking for
the ring speed of your network.
4 Enter the correct ring speed and configuration mode and
press [Enter].
This adapter can run at 16 or 4 Mbps. The ring speed for the
adapter and the network must be the same. Ask your system
administrator for the correct ring speed.
Upon successful completion, a message appears, stating that
the AutoLink program has completed the configuration.
5 Remove the TokenDisk diskette and press any key to
reboot your PC.
The login prompt for a NetWare server appears.
6 Log in to the NetWare server using your user ID and
password provided by your network administrator.
The 3C619C adapter is now a NetWare DOS ODI client.
Installation and configuration are complete. If you have
problems, see Chapter 7, "Troubleshooting," for help.
3: U A L
SING THE UTO
F N
INK EATURE FOR ET
W
ARE