Aily Perations - HearthStone Santa Fe 8761 Owner's Manual

Gas-fired direct vent heater
Hide thumbs Also See for Santa Fe 8761:
Table of Contents

Advertisement

Hearthstone Quality Home Heating Products, Inc.
L
I
IGHTING
NSTRUCTIONS
1. Set the on/off/T-stat switch or thermostat to
the off position.
2. Unplug the blower accessory, if so equipped.
3. Push in and turn gas control knob clockwise
".
to "OFF
(If not previously lit, the knob
should be in this position.)
4
Wait (5) five minutes to clear out any gas.
.
If you then smell gas, STOP! Smell all
around the appliance area for gas. Be sure
to smell next to the floor because some
gases (LPG) are heavier than air and will
settle on the floor. If you smell gas
immediately, follow the What To Do If You
Smell Gas! warning on the cover of this
Manual. If you do not smell gas, go to the
next step.
5. Turn gas control knob counterclockwise to
"PILOT".
6. Push in control knob all the way and hold in.
Immediately light the pilot with the gas
lighter (push in and "click" the piezoelectric
spark igniter button several times until lit).
Continue to hold the control knob in for
about 20 seconds after the pilot is lit.
Release the knob and it will pop back out.
Pilot should remain lit. If the pilot goes out,
repeat the operation.
If knob does not pop out when released,
stop and immediately call a qualified
service technician or gas supplier.
If the pilot will not stay lit after several
tries, turn the gas control knob "OFF"
and call a qualified service technician or
gas supplier.
7. Turn gas control knob counterclockwise to
"ON".
8. Select "ON" or "T-STAT" position on the
on/off/t-stat switch.
9. Shut the gas control valve access door.
10. Plug in the blower accessory, if so equipped.
11. Set thermostat to "ON" and set the desired
temperature setting.
Normally, if the "T-STAT" position was
selected, the main burner is cycled on and off by
the Thermostat or the "on", "off" switch located
on the bottom of the Thermostat body.
T
T
O
T
O
URN
FF
HE
Turn the gas control knob clockwise to "OFF"
position. If shutting the unit off for the non-
heating season, this will improve the overall
efficiency of the unit as the heat from the pilot is
wasted in the summer. When putting the unit
back into service follow the lighting instructions
described on this page.
V
O
ARIABLE
UTPUT
The gas control valve is equipped with a
variable output control. This control varies the
rate of heat produced by the unit by varying the
gas pressure to the main burner tube.
D
O
AILY
PERATIONS
The homeowner easily operates the Santa Fe
gas-fired heater. The unit comes with a standard
thermostat.
Remote
switches are available for purchase from your
local Hearthstone dealer. Once the thermostat is
installed and properly adjusted, the desired room
temperature is maintained.
variable output control located on the gas control
valve, the rate of heat output can be varied to
meet the heating requirements of the season.
Choosing a low flame setting will result in
longer burn cycles at a reduced output, while
choosing a high flame setting will result in a
shorter, hotter burn cycle. Through trial and
error, the homeowner can select the optimum
flame size for their setting, and application. Also
available is a variable speed blower. (Kit# 93-
57010)
4
SANTA FE Model 8761
G
T
T
A
AS
O
HE
PPLIANCE
C
ONTROL
thermostats,
or
By adjusting the
wall

Advertisement

Table of Contents
loading

Table of Contents