Eplacing The Lass; Placement; Nstallation Of The Og Et - HearthStone Santa Fe 8761 Owner's Manual

HearthStone Quality Home Heating Products Inc
R G
EPLACING THE LASS
To replace the front glass, shut the pilot light off.
Remove the front screw, using the 1/8" hex
wrench provided. Open the door. Take care and
pull the door up and remove it from its hinges.
Remove the eight Phillips head screws in the
frame and pull the frame and glass off the door.
If the glass is broken, pull the broken fragments
of glass away from the door using heavy-duty
gloves, as the pieces will be very sharp.
Carefully replace the glass gasket as necessary,
and replace the door.
•
WARNING! Do
materials. Use only parts that have been
supplied by Hearthstone, through an
authorized Hearthstone dealer.
•
CAUTION! Do not clean the glass while
the unit is hot. Allow approximately one
hour before attempting cleaning.
L P
OG LACEMENT
Place only the decorative ceramic log set
supplied with the unit in the firebox. This log set
is specifically designed to work with the
provided pan burner. Do not use any other type
of ceramic logs, wood logs, or other materials in
the firebox. If the original log set is damaged, or
broken, contact your Hearthstone dealer for
replacement. The decorative ceramic log set will
last a long time, however, they will break easily
if subjected to rough or improper handling.
Exact positioning of the log set is required in
order to obtain a pleasing flame pattern and
efficient combustion. Incorrect log placement
can cause carbon build-up; excess thermal stress
on the log set and stove parts, reduced
efficiency, and high levels of carbon monoxide.
If the log set does not fit into the firebox exactly
as outlined, contact your dealer for assistance.
I
NSTALLATION OF THE
(Refer to the figures in this section)
Caution-Do not place embers near the pilot.
1. Open the front door using a 1/8" hex
wrench. Loosen the bolt that fastens the
doorknob to the door. It also unfastens the
door from the firebox by turning it
counterclockwise. Be careful not to chip
not use substitute
L S
OG ET
SANTA FE 1 Gas-Fired Direct Vent heater
the enamel when loosening the bolt. Pull
the door open by grabbing the top edge of
the doorframe.
WHEN INSTALLING THE LOGS BE
SURE NOT TO COVER ANY SLOTTED
PORTS ON THE BURNER SURFACE
2. Remove the packaging material around
the log set assembly. Be careful not to damage
the log set when unpacking. Observe the 5
mounting "posts", A, B, C, D, and E.
3.
Gently slide the Y-shaped Log (1) onto
pins A and C, as shown below.
4. Gently slide the longer, "half" log (2)
onto pin D. Be sure to position the rear of the
log in front of the pilot assembly and against
the left side of the firebox as shown below.
5.
Gently slide the shortest of the "half"
logs (3) onto pin B as shown below
17
.