Yujin Robot Iclebo smart YCR-M04-01 User Manual page 13

Cleaning
mode
Timer
cleaning
1. Press Timer button of the remote control.
Time display will flash on the display screen.
[Note] If the time was set already, it will show the previous setting.
Press the button again to set the timer.
2. Set the "Hour" with TIME (+), (-) button to desired time.
3. Press Enter button to confirm. Display screen will show the set time.
4. Set the "Minute" with TIME (+), (-) button. Display screen will show the set minute.
5. Press Enter button after setting the desired time.
Display screen will show the timer time and the timer icon(
Robot cleaner will start cleaning on the set time.
6. To cancel the timer, press Timer button then press Enter button when the time display flickers
on the display screen.
12
User can set the cleaning mode with Mode button on the main body
or remote control.
(But, cleaning mode can be changed when the robot cleaner is stopped)
As a normal cleaning mode, it moves in zig-zag to clean.
- In case the battery is short during cleaning, it will
Auto
charge first then return to its last location and resume.
- But, it must start from the charging station.
mode
- It is set not to go over the carpet or barriers
with more than 5mm.
This is for cleaning the carpet.
Carpet
mode - It moves randomly on the carpet to clean.
It can climb around 13mm high threshold and cleans.
Climb
mode
- With climb mode, robot cleaner moves in zigzag direction.
Install microfiber wet mop then start mopping mode.
- Dust bin and main brush must be separated from
Mopping
the main body to install wet mop before use. (Refer to page 8)
mode
- It is set not to go over the carpet or barriers
with more than 5mm.
Timer setting Robot cleaner will operate automatically on the set time
even the user is out. [Note] Current time must be set to use timer cleaning.
1 1 2 2 3 3 4 4
※Refer to page 10 for setting the current time.
) will appear.
5 5