Step 2 Create The Sequence - Roland EGX-600 User Manual

5-2. Basic Steps for Creating and Executing a Sequence

Step 2 Create the Sequence

Now let's actually create the sequence. First carry out operations without loading a workpiece. We'll assume that the Z0
position is set at the surface of the workpiece.
Example of Sequence Creation
1
Press
shown at right, then move the blinking cursor
to [TEACHING]. Press
ing cursor to [EDIT], then press
2
Specify creation of a new sequence. Make sure
the blinking cursor is at [Yes], then press
The sequence editing screen appears.
3
Turn the dial to make the display change to [1
MOVE-LIMIT]. Press
You have now finished entering the commands to move
the spindle to the machine origin point at the highest speed
as the first step. When you finish making the entries for
the first step, the display changes to the input screen for
the second step.
4
Turn the dial to make the display change to [10
SP OFF]. Press
play [ON]. Press
to display [100]. Press
Now you have entered the commands for rotating the
spindle. [100] means rotation at 10,000 rpm. Now the
input screen for the third step appears.
5
Turn the dial to display [3 MOVE-ZM]. Press
.
The screen changes to the coordinate view.
6
Press
and Y axes to the first cutting point (X 2000, Y
1000). Next, press
a location 1 millimeter from the surface of the
workpiece (Z 100). Press
Check the displayed coordinates as you perform move-
ment. Now you have entered the commands for moving
the X and Y axes to the specified position, then lowering
the Z axis at the highest speed to a position close to the
surface of the workpiece. Next, the input screen for the
fourth step appears.
Chapter 5 - The Teaching Feature
74
several times to display the screen
. Move the blink-
.
, then turn the dial to dis-
again, then turn the dial
.
to move the X
to move the Z axis to
.
.
.
I/O OTHERS
TEACHING SELF
RUN DELETE
EDIT SETTING
Edit New File ?
Yes No
1:
< 1 MOVE-LIMIT >
2:
< 10 SP ON 100 >
3:
3 MOVE-ZM
X 2000 Y 1000
Z 100 8000RPM