Table of Contents
Advertisement
3-2. Cutter Installation Method 1 (With Nose Unit)
14
Close the spindle cover.
Cutting Parameters When Using the Nose Unit
When you use the preceding method, there is no need to set the cutting-in depth or the cut-out amount by a software or
the operation panel. The cutting-in depth is determined mechanically by the amount of tightening of the nose unit.
For more information about how to set the cutting parameters
See p.59 "Setting the Cutting Parameters"
See p.134 " Examples of Settings for Cutting Parameters"
For detailed information about the nose unit
See p.110 "Detailed Description of the Menus," the section " AUTO Z CONTROL "
See p.103 "Detailed Description of the Nose Unit"
1.
3.
2.
Chapter 3 - Preparations
41
Advertisement
Table of Contents
