Roland EGX-600 User Manual page 58

3-5. Cutter Installation Method 4 (End Mill)
3. Aligning the Cutter
9
Load a workpiece and move the end mill to the
top surface of the material.
For information on how to load material
See p.55 "Loading Material and Setting the Reference Point for Cutting"
10
Close the spindle cover.
11
Hold down
The spindle rotates.
12
Lower the spindle a little at a time, and stop it
when it is just barely cutting the surface of the
workpiece. Press
13
Use the menus to set the height reference point (Z0).
(1) Press
(2) Make sure the blinking cursor is at [Z0], then press
(3) Press
Chapter 3 - Preparations
54
for 0.5 seconds or longer.
to stop the spindle.
.
to return to the top screen.
1.
3.
2.
SET Z1
SURFACE
.
Z0 Z2
< 0 >