Wiring The Fan - Hunter Type 3 Owners And Installation Manual

A
B
C
D
Step 6-3
A • Ground/Green
Step 6-4
B • Ceiling Black
• Receiver Black: "LIVE IN"
C • Ceiling White
• Receiver White: "NEUTRAL IN"
Step 6-5
D • Fan Black/White
• Receiver Red: "LIGHT OUT"
E • Fan Black
• Receiver Black: "FAN OUT"
F • Receiver White: "COMMON OUT"
• Fan White
All wiring must be in accordance with
national and local electrical codes and
ANSI/NFPA 70. If you are unfamiliar with
wiring, use a qualified electrician.
Large Wire Connector
Small Wire
Connector
6 • Wiring the Fan
6-1. Before attempting installation, make sure the power is still off.
Receiver
6-2. To connect the wires, hold the bare metal leads together and place
a wire connector over them, then twist clockwise until tight. For all
these connections use the wire connectors provided.
CAUTION: Be sure no bare wire or wire strands are visible after making
connections.
6-3. Using a large wire connector, connect the ground wire from the
ceiling to the green wire from the ceiling plate and the green ground
F
wire from the downrod.
6-4. Using the large wire connectors, connect the white wire and the
E
black wire from the ceiling as follows:
• The white (common) power wire from the ceiling to the white
wire from the receiver (marked on red tag "NEUTRAL IN")
• The black power wire from the ceiling to the black wire from the
receiver (marked on red tag "LIVE IN")
6-5. Using the small wire connectors, connect the wires from the fan as
follows:
• The black/white wire from the fan to the red wire from the
receiver (marked on white tag "LIGHT OUT")
• The black wire from the fan to the black wire from the receiver
(marked on white tag "FAN OUT")
Steps 6-3 – 6-5
• The white wire from the fan to the white wire from the receiver
(marked on white tag "COMMON OUT")
6-6. Check each connection to make sure no bare wire or wire strands
are visible. Turn the splices upward and push them carefully back
through the ceiling plate into the outlet box.
6-7. Spread the wires apart, with the ground wires on one side of the
outlet box and the ungrounded wires on the other side of the outlet
box.
6-8. Position the receiver in the canopy so that the antenna is close to
the edge of the ceiling plate for clear reception.
12
45066-01 • 03/03/10 • Hunter Fan Company