Table of Contents
Advertisement
1
While holding the wires out of the way, lift the
motor assembly and place the square hanger
into the opening in the ceiling bracket. Be sure
the ground wire attached to the hanger faces
out of the large opening in the ceiling bracket.
We know wiring is hard. Let's make it easier.
Follow these steps to get your fan wired quickly and safely. Follow the route be-
low that best matches your wall switch setup. If you are unfamiliar with wiring or
uncomfortable doing it yourself, please contact a qualified electrician.
Have a single switch?
Follow these steps:
Connect the three
grounding wires (green,
green/yellow stripe, or
bare copper) coming from
the ceiling and hanging
bracket.
Have dual switches?
Follow these steps:
Connect the second
ungrounded (light)
wire from the
ceiling to the blue
Blue
wire from the fan.
Connect the three
grounding wires (green,
green/yellow stripe, or
bare copper) coming from
the ceiling and hanging
bracket.
Ceiling Bracket
Hanging Fan
NOTICE
To prevent damage to fan,
ALWAYS lift holding either the
fan housing or the downrod.
Grounding
WARNING
All wiring must be in accordance with
national and local electrical codes ANSI/NFPA
70. If you are unfamiliar with wiring or in
doubt, consult a qualified electrician.
Grounding
Wiring
Hanging the Fan
2
Once the motor is in the ceiling bracket,
use the two locking screws found in the
hardware bag to secure the motor
to the ceiling bracket.
Wiring the Fan
Black
Motor Housing
Hunter Pro Tip:
Here is how to connect the wires:
Push the bare metal ends of the wires together and slide a wire
nut over them. Then, twist the wire nut clockwise until tight.
Give it a gentle pull to make sure none of the wires are loose.
Connect the white
(grounded) wire from
the ceiling to the white
wire from the fan.
White
Connect the black wire
(ungrounded) from the
ceiling to the black and the
blue wires from the fan.
Hunter Pro Tip:
Have extra wiring?
Turn the wires upward and push them carefully back through
the hanger bracket into the outlet box. Make sure that the
wires are still attached to the wire nuts.
Connect the white
(grounded) wire from
the ceiling to the white
wire from the fan.
White
Connect the black wire
(ungrounded) from the
ceiling to the black
wire from the fan.
Black
Blades
1886
x2
bag
Locking
Screw
x4
bag
Wire Nut
x4
bag
Wire Nut
4
Light
Advertisement
Table of Contents
