Table of Contents
Advertisement
5. Install the drive into the bay. Align the screw holes, and insert the two screws.
6. Each integrated drive electronics (IDE) drive requires two cables; a four-wire
The steps to connect an IDE drive are different depending on the type of drive you
are connecting. Locate the procedure below for your drive connection.
To connect the first IDE CD drive or DVD drive
1. Locate the three-connector signal cable that came with your computer or with
2. Locate the secondary IDE connector on the system board. See "Identifying parts
3. Connect one end of the signal cable to the drive and the other to the secondary
4. Your computer has extra power connectors for additional drives. Connect a
54
Hardware Maintenance Manual
power cable that connects to the power supply and a signal cable that connects
to the system board. You might also have an audio cable to connect.
the new drive.
on the system board - microtower model" on page 48.
IDE connector on the system board. To reduce electronic noise, use the
connectors at the end of the cable only.
power connector to the drive.
Hide quick links:
Advertisement
Table of Contents
