IBM 2254 Hardware Maintenance Manual page 10

DID YOU RECEIVE THE CORRECT RESPONSE?
If NO, continue to 002 .
If YES, proceed to 003 .
If the Power Management feature is enabled, do the following:
1. Start the Configuration/Setup Utility program (see "Setup Utility program" on
2. Select Power Management from the Configuration/Setup Utility program
3. Select APM.
4. Be sure APM BIOS Mode is set to Disabled. If it is not, press Left Arrow (}) or
5. Select Automatic Hardware Power Management.
6. Set Automatic Hardware Power Management to Disabled.
7. If the problem persists, continue to 003 .
Run the Diagnostic programs. If necessary, refer to "Diagnostics" on page 12.
v If you receive an error, replace the part that the diagnostic program calls out or
v If the test stops and you cannot continue, replace the last device tested.
2
Hardware Maintenance Manual
002
page 10)
menu.
Right Arrow (Æ) to change the setting.
003
go to "Symptom-to-FRU Index" on page 69.