TOHATSU MFS 6A3Z 8A3 9.8A3 Owner's Manual page 46

46
ENGINE OPERATION
decrease.
Furthermore, the bow may sway or the
bottom may slam the water while cruising.
In this case, decrease the trim angle by
pressing the switch on the remote control
level to "DN".
DN
ENOM00058-0
Improper trim angle (bow dips into the
water)
If the trim angle is too small, the bow will
dip into the water, the speed will decrease,
and water may enter the boat. In this case,
the trim angle should be increased by
pressing the switch on the remote control
lever to "UP".
UP
EFT type
EPT type
ENOF00056-0
ENOM00059-0
Proper trim angle
The trim angle is optimum when the boat
is parallel to the water surface while run-
ning.
ENOM00532-0
MF, EF type
1. Stop the engine.
2. Shift the outboard into neutral.
3. Raise the engine to the tilt up position.
4. Change the thrust rod position.
5. Gentry lower the outboard.
ENOF00057-0
ENOF00534-0
ENOF00535-0