TOHATSU MFS 6A3Z 8A3 9.8A3 Owner's Manual page 21

Nm (3.0 kgf) 13 ft-lb). Check the fasten-
ers for tightness from time to time.
Be sure to use outboard mounting fas-
teners included in the outboard motor
package or their equivalents in terms of
size, material, quality and strength.
Tighten fasteners to the specified torque
(30 Nm (3.0 kgf) 13 ft-lb). Test cruise to
c h e c k i f f a s t e n e r s a r e t i g h t e n e d
securely.
Outboard motor mounting must be per-
formed by trained service person(s)
using lift or hoist with sufficient capacity.
ENOM00511-0
EFT, EPT type (Power tilt model)
ENON00510-0
Note
It is recommended to install upper mounting
bolts with bolt head at inside surface of tran-
som. Bolts with threaded end at inside sur-
face of transom can cause personal injury.
ENON00003-0
Notes
1. Apply sealing agent, such as silicone
ENOF00507-0
2. Be sure to tighten the mounting bolt
ENOW00009-0
Mounting the outboard motor without
following this manual can lead to unsafe
conditions such as poor maneuverabil-
ity, lack of control or fire.
Loose clamp screws and/or mounting
bolts can lead to the release or displace-
ment of the outboard motor, possibly
resulting in lost of control and/or serious
INSTALLATION
sealed between the bolts and the tran-
som board holes before tightening the
bolts.
nuts to the specified torque.
(30 Nm (3.0 kgf) 13 ft-lb)
WARNING
21
ENOF00508-0