2
1
1. Shift cable
2. Throttle cable
3. Cable harness
ENOW00100-0
CAUTION
Be careful not to loop the remote control
cables to a diameter of 406 mm (16 inches)
or less.
ENON00005-0
Note
Confirm the outboard motor shifts correctly
when the shift lever is placed in Forward and
Reverse position. also confirm the throttle
valve is closed at idle, in Neutral, Forward,
and Reverse. Confirm the throttle valve is
fully open when in Forward at the wide open
position.
3. Connecting the Cord assembly (Wiring
Harness)
Pass the Cord assembly from the Remote
control box through the hole in the Lower
motor cover and cover the wire ends with
the Sleeve (provided in a tool bag) and
then connect the electric terminals accord-
ing to the drawing below.
ENOW00011-0
Do not disconnect the cord assembly when
the outboard motor is in operation or you
will lose control of the outboard motor.
3
ENOF00510-0
INSTALLATION
WARNING
23