HIKVISION Network Speed Dome Camera User Manual page 78

User Manual of Network Speed Dome
2. Check the checkbox of Enable Record Schedule to enable scheduled recording.
3. Set the record parameters of the speed dome.
 Pre-record: The time you set to start recording before the scheduled time or
the event. For example, if an alarm triggers recording at 10:00, and the
pre-record time is set as 5 seconds, the speed dome starts to record at
9:59:55.
The Pre-record time can be configured as No Pre-record, 5 s, 10 s, 15 s, 20 s,
25 s, 30 s or not limited.
Note: The pre-record time changes according to the video bitrate.
 Post-record: The time you set to stop recording after the scheduled time or
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
Figure 7-5 Recording Schedule Interface
Figure 7-6 Record Parameters
77