Chapter 2 Network Connection; Setting The Network Speed Dome Over The Lan; Wiring Over The Lan - HIKVISION Network Speed Dome Camera User Manual

User Manual of Network Speed Dome

Chapter 2 Network Connection

Before you start:
 If you want to set the network speed dome via a LAN (Local Area Network),
please refer to Section 2.1 Setting the Network Speed Dome over the LAN.
 If you want to set the network speed dome via a WAN (Wide Area Network),
please refer to Section 2.2 Setting the Network Speed Dome over the WAN.

2.1 Setting the Network Speed Dome over the LAN

Purpose:
To view and configure the speed dome via a LAN, you need to connect the network
speed dome in the same subnet with your computer, and install the SADP or
iVMS-4200 software to search and change the IP of the network speed dome.
Note: For the detailed introduction of SADP, please refer to Appendix 1.

2.1.1 Wiring over the LAN

The following figures show the two ways of cable connection of a network speed
dome and a computer:
Purpose:
 To test the network speed dome, you can directly connect the network speed
dome to the computer with a network cable as shown in Figure 2-1.
 Refer to the Figure 2-2 to set the network speed dome over the LAN via a switch
or a router.
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
Figure 2-1 Connecting Directly
14