Operation - LIND DC Power Adapters Operating Instructions Manual

MaxPower
Smart Power Solutions

Operation

1. The MaxPower includes a specific tip for your
notebook computer brand and models.
Before operating your notebook computer with the
MaxPower, you should make sure that your MaxPower
battery has the same output voltage rating as your
AC/DC adapter. If you are not sure then please
contact your local dealer to verify whether the battery
works with your notebook computer.
Warning : Choose the correct voltage and tip for your
notebook computer. Using the incorrect
voltage and tip may damage your notebook
computer or make it malfunction.
2. Connect the selected tip to the end of MaxPower
output cable after aligning the arrows on the tip
and output cable plug.
6 User's manual
Smart Power Solutions
output
output
3. Insert the other end of MaxPower output cable into the
output port of the battery.
4. Plug the SmartTip end into the AC port of your notebook
computer where the AC adapter would normally connect.
5. Turn on your notebook computer and begin to work.
Note : If the MaxPower becomes hot and the LEDs display
red-blinking lights during use, disconnect the
output cable from the notebook immediately.
Please wait until it cools down then connect the
output cable to the notebook again. If the LEDs are
still red-blinking, power the battery with AC
adapter for one minute. If the red blinking lights
continue to be displayed, contact the location
where it was purchased for further assistance.
Prior to exhausting the battery's power supply,
a warning beep will sound notifying you to shut
MaxPower
User's manual 7