LIND DC Power Adapters Operating Instructions Manual page 128

TECHNICAL INFORMATION
Input voltage
Output voltage
Output current
Output 1 (Term. Block)
Output 2 (Cig. Socket)
Fuse Type
Disconnect voltage*
Reconnect voltage
Indicators
* This is the disconnect voltage as measured at the module.
The actual battery voltage will be higher due to voltage drop in the wiring.
INSTALLATION
Mount the LIVCO Module in a cool, dry place in the vehicle. Do not mount
the module in the engine compartment. The module is connected between
the +12V of the vehicle electrical system and the loads to be controlled.
The LIVCO Module +BAT terminal must be connected to the system +12V
through a suitable fuse, using appropriately sized wire for the current draw,
and length of wiring. Connect the GND terminal to a good chassis ground
with a suitably sized wire. The internal circuitry and the cigarette socket
is grounded through this connection. Loads connected to the +Output 1
terminal must have their ground connection made to a good chassis ground.
Lower value fuses may be used for more precise protection.
+OUTPUT #1
CIGARETTE
SOCKET
+OUTPUT #2
GND
+BAT
10 – 16 VDC
Tracks input
30A Total
15A Max.
15A Max.
15A ATO Auto fuse (blue)
10.1 – 10.5 VDC
11.8 – 12.2 VDC
Green LED indicates when
outputs are ON
TO CHASSIS GROUND
TO LOADS