LIND DC Power Adapters Operating Instructions Manual page 126

Lind LIVCO Booster Module
The Lind LIVCO Booster Module maintains 12 VDC to sensitive electronic
loads when the main 12 VDC source temporarily drops below 11 VDC, as
may occur during vehicle starting.
• Maintains 12 VDC output at up to 8 amps, down to 6 VDC input
voltage, for up to 10 seconds.
• Available with DC power jacks or with terminal block connections.
• Can be used with Lind DC power adapters or other 12 VDC loads.
• Housed in a rugged aluminum case.
• LIVCO (Low Input Voltage Cut Off) circuitry shuts the adapter off
if the input voltage is low for more than 10 seconds, protecting the
source voltage and the adapter.
To connect: Remove the input (cigarette lighter cable or other
input connection from the Lind DC adapter and connect this
cable to the input of the LIVCO Booster Module. Connect the
short output cable provided with the LIVCO Module between
input jack of the Lind DC adapter and the output jack of the
Module. The output cable of the Lind DC adapter will remain
connected between the device it is powering and the DC adapt-
er. The input cable, now connected to the LIVCO Module, will
remain connected to the source DC input voltage.
Lind LIVCO Booster ModuleThe Lind LIVCO Booster Mod-
ule maintains 12 VDC to sensitive electronic loads when the
main 12 VDC source temporarily drops below 11 VDC, as may
occur during vehicle starting.