Mechanical Design; Front Panel - OPTOKON EDFA User Manual

6 Mechanical design

6.1 Front panel

Block on the panel
PRE-AMP 1
BOOSTER 1
PRE-AMP 2
BOOSTER 2
COMPUTER
DIAG.
KEY
WARNING:
 Use only APC connectors (chapter 2.2)
 Optical connector must be clean (chapter 2.2)
 In case of active RED LED (EDFA alarm) - switch KEY to the Disable
position.
CLA-PB01F-NSC-D-AC
CLA-CA16-20-NSC-M-D-AC
Legend Description
IN Pre-Amplifier 1 Input
OUT Pre-Amplifier 1 Output
Monitor 1% Monitor of Pre-Amplifier 1 input (optionally)
IN Booster Amplifier 1 Input
OUT Booster Amplifier 1 Output
Monitor 1% Monitor of Booster Amplifier 1 input (optionally)
IN Pre-Amplifier 2 Input
OUT Pre-Amplifier 2 Output
Monitor 1% Monitor of Pre-Amplifier 2 input (optionally)
IN Booster Amplifier 1 Input
OUT Booster Amplifier 1 Output
Monitor 1% Monitor of Booster Amplifier 1 input (optionally)
ON/OFF ON/OFF button PC
Reset Reset button PC
HDD HDD LED PC
5V Green LED indicates 5V
12V Green LED indicates 12V
Blue LED indicates active pump diode – the amplified
Pump
optical signal is at the output ports
Yellow LED indicates LOSS of input/output power alarm
Loss
(chapter 13)
!
RED
temperature of pumping diodes or module is out of
range, the pumping current exceeds limit for end of
life current (chapter 13)
Enable/Disable Amplifier ENABLE/DISABLE
EDFA optical amplifier – user manual
LED indicates EDFA
13
critical alarm –