Installation; Preparation; Installation Procedure; Tools Required - Motorola PTP 600 Series User Manual

7

Installation

Motorola recommends that only qualified personnel undertake the installation of a PTP 600
Series Bridge solution.
7.1

Preparation

Before proceeding with the installation you should:
•
Check the contents of all packages against the parts lists shown in the packing list.
•
Ensure that you have the correct tools for the job.
•
Ensure that you are qualified to undertake the work.
•
Ensure that you have taken the correct safety precautions.
•
Have completed the site planning as described in section 6 "Site Planning".
7.2

Installation Procedure

The 600 Series installation procedure consists of the following steps:
•
Mounting the ODUs, section 7.6
•
Connecting up, section 7.7
•
Mounting the PIDU Plus units, section 7.7.8
•
Powering Up, section 7.7.10
•
Aligning the ODUs, section 7.7.11
7.3

Tools Required

The following specific tools are required to install a PTP 600 Series Bridge in addition to
general tools:
•
13mm Spanner / Wrenche
•
RJ45 Crimp Tool
•
IBM Compatible Personal Computer (PC) running Windows 98 or later with 10, 100 or
1000 BaseT Ethernet (Ability to change IP settings easily is recommended)
•
Either Internet Explorer version 6 or higher, or FireFox 1.5 or higher are recommended.
•
Ethernet patch cable
•
6mm general purpose crimp tool for the grounding lug (optional for Lightning Protection)
50