Turning Do Not Disturb On And Off; Trace Call: Identifying Anonymous Callers (Not For U.s.); Answering Calls From The Entrance Telephone And Opening The Door - Siemens HiPath 500 Operating Instructions Manual

Making and Answering Calls
Step by Step
or
12

Turning Do Not Disturb On and Off

You can activate the do not disturb function if you do not
want the receive any calls. When do not disturb is
activated, internal callers hear a busy signal and external
callers are rerouted to a telephone assigned for this
purpose (contact the service personnel).
n
Lift the handset.
w
Enter the code for "on" or "off".
When you lift the handset, a special dial tone
(continuous buzzing) reminds you that "do not
disturb" is active.
Authorized internal callers can automatically
override the do not disturb function after five sec-
onds.
Trace Call: Identifying Anonymous
Callers (Not for U.S.)
You can have the carrier identify malicious external
callers. You can save the caller's station number during
the call or for 30 seconds after the call ends. However,
it is essential that you do not replace your handset
during this time.
s
You are engaged in an external call.
Enter the code.
After you have finished tracing the call, the data
is stored on the carrier's system. Now contact
the service personnel.
Answering Calls from the Entrance
Telephone and Opening the Door
If an entrance telephone has been programmed, you
can use your telephone to speak to someone at the en-
trance telephone and to activate a door opener.
If you are authorized to activate a door opener (contact
the service personnel), visitors can open the door them-
selves by entering a 5-digit code (using a DTMF trans-
mitter or installed keypad).