Web Configurator; Login Username And Password - Telkom ADSL 5100 Instruction Manual

A.4 Web Configurator
I cannot access the web configurator.
STEPS
1 Make sure you are using the correct IP address of the TELKOM ADSL 5100. Check the
IP address of the TELKOM ADSL 5100.
2 Make sure that there is not a console session running.
3 Check that you have enabled web service access. If you have configured a secured
client IP address, your computer's IP address must match it. Refer to the chapter on
remote management for details.
4 For WAN access, you must configure remote management to allow server access from
the Wan (or all).
5 Your computer's and the TELKOM ADSL 5100's IP addresses must be on the same
subnet for LAN access.
6 If you changed the TELKOM ADSL 5100's LAN IP address, then enter the new one as
the URL.
7 Remove any filters in LAN or WAN that block web service.
8 See also Section A.9.
The web configurator does not display properly.
STEPS
1 Make sure you are using Internet Explorer 5.0 and later versions.
2 Delete the temporary web files and log in again.
In Internet Explorer, click Tools, Internet Options and then click the Delete Files ...
button.
When a Delete Files window displays, select Delete all offline content and click OK.
(Steps may vary depending on the version of your Internet browser.)
A.5 Login Username and Password
I forgot my login username and/or password.
STEPS
1 If you have changed the password and have now forgotten it, you will need to upload the
default configuration file. This will erase all custom configurations and restore all of the
factory defaults including the password.
2 Press the RESET button for five seconds, and then release it. When the SYS LED
begins to blink, the defaults have been restored and the TELKOM ADSL 5100 restarts.
Or refer to the Resetting the TELKOM ADSL 5100 section for uploading a configuration
CORRECTIVE ACTION
CORRECTIVE ACTION
CORRECTIVE ACTION
73