Carrier RAV-SP180UT-UL Service Manual page 171

No. Part name
‚
Electric parts 1) Perform work of item
assembly
2) Take off drain guide fixing screws (2pcs)
3) Pull out TC and TCJ sensors from the
4) Take off the connentor cover mounting screw
5) Take off the clamp base mounting screw
6) Take off the mounting plate mounting screw
7) Remove the fan motor connector (5P) and
8) Disengage the display unit by simply
9) Remove the fixing screw that secures the
ƒ
Horizontal 1) Remove shaft of the horizontal louver from
louver
Procedures

senser holder of the heat exchanger.
(When reassembling the elect parts ,be
careful to the attaching positions of every
seneor. TC and TCJ sensors resemble in the
shapes , so distinct them by making ,etc.
when mounting them.)
(1pc.) and then remove the connector cover.
(1pc.) and then remove the clamp base.
(1pc.) and then remove the mounting plate.
the connector for louver motor (5P) from the
P .C. board.
pushing at the top of the display unit.
electrical parts box assembly, LED assembly
and remove the assembly.
the back body. (First remove the left shaft,
and then remove other shafts while sliding
the horizontal louver leftward.)
.
Mounting plate Mounting plate Mounting plate
fixing screw fixing screw fixing screw
Mounting plate Mounting plate Mounting plate
– 171 –
Remarks
Drain guide Drain guide Drain guide
Drain guide Drain guide Drain guide
Connector cover Connector cover Connector cover
fixing screw fixing screw fixing screw
fixing screw fixing screw fixing screw
Earth screw Earth screw Earth screw
TCJ sensor TCJ sensor TCJ sensor
(Ø6 sleeve provided) (Ø6 sleeve provided) 6 sleeve provided)
TC sensor TC sensor TC sensor
(Ø6 sleeve not provided) (Ø6 sleeve not provided) 6 sleeve not provided)
Clamp base Clamp base Clamp base
Fixing screw Fixing screw Fixing screw
Connector Connector Connector
cover cover cover
Fan motor Fan motor Fan motor
connector connector connector
Louver Louver Louver
motor motor motor
connector connector connector