No.
Part name
1. Detachment
Electric
3
parts box
1) Carry out works of Detachment of
2) Remove the power supply wire and the
3) Remove the power supply wire from cord
4) Remove screws (M4, 10 mm, 2 pcs.) of the
5) Hook the hooking section temporarily at the
2. Attachment
1) Insert the square hole of the electric parts
2) Attach screws (M4, 10 mm, 2 pcs.) to the
3) Connect the power supply wire and the
4) Carry out works of Attachment of 1 and 2 .
Procedure
remote controller wire from the power
supply terminal block and the remote
controller terminal block each.
clamp at side of the electric parts box.
electric parts box and pull out downward.
rear side of the electric parts box to the
sheet fittings part of the main unit.
box into the claw of the main unit.
electric parts box.
remote controller wire as before.
and
.
1
2
Remote controller
terminal block
Square hole of
electric parts box
– 160 –
Remarks
Electric
terminal block
Cord clamp
Screw
Hooking sections
g
of electric parts box
Sheeted folding up
section of main unit
Claws of main unit