Carrier RAV-SP180UT-UL Service Manual page 151

No. Part name
1. Detachment
Control
5
P .C. board
1) Carry out work of Detachment of
2) Remove connectors which are connected
NOTE :
Unlock the lock of the housing part and then
remove the connector.
3) Unlock the locks of the card edge spacer
2. Attachment
1) Fix the control P .C. board to the card edge
2) Connect the connector removed in the
3) Following to work of Attachment of
Procedure
from the control P .C. board to the other parts
and then remove wiring from the clamp.
CN510 : Louver motor (20P , White)
CN34 : Float switch (3P , Red)
CN504 : Drain pump (2P , White)
CN101 : TC sensor (2P , Black)
CN102 : TCJ sensor (2P , Red)
CN104 : Room temp. Sensor (2P , Orange)
CN333 : Fan motor power supply
(5P , White)
CN334 : Fan motor position detection
(3P , White)
(6 positions) and then remove the control
P.C. board.
spacer (6 positions)
above Detachment as before and then fix
the wiring with the clamp.
mount the electric parts box cover and the
suction grille as before.
.
2
Card edge spacer Card edge spacer
,
2
– 151 –
Remarks
Clamp