Connecting The Water Supply; Connecting The Water Outlet - Franke bremer VIVA Operating Instructions Manual

11.3 Connecting the water supply

D Observe the national guidelines for the water connection.
D For a water hardness of over 5° dkH (carbonate hardness), we recommend that
you have to install a water softener in the water inlet line. Observe the
instructions on installing and using the water softener.
D We recommend to install an electronic water monitor to guard against water
damage.
D A water tap and water filter must be installed in an easily accessible position
upstream of the water inlet hose.
D Use a fabric pressure hose which does not corrupt taste to extend the supply
hose. The diameter must not be smaller than the supply hose fitted at the
factory.
D Before connecting, rinse through the water line and the fabric pressure hose so
that no dirt particles enter the coffeemachine.
D Check all connections for leaks.
D Maximum water line pressure: 1.0 MPa (10 bar).
D Minimum flow pressure: 0.3 MPa (3 bar).
D Water temperature: up to approx. 40° C.

11.4 Connecting the water outlet

D Install a stench trap on the drainage hose (siphon).
D Lay the hose with a gradient to the drain.
D Seal and secure the hose at the drainage pipe.
D The inlet and drainage hoses must not be bent or squashed.
47