Installation
The 6402 and 6402D can be either desk-mounted or wall-mounted. Use the
following directions for installing either telephone. Figure 2 shows the back of
the 6402 and 6402D telephones.
FIGURE 5 The Bottom of the 6402 and 6402D Telephones
Desktop Installation
Note: You may use the 6400 Series telephones without the desktop stand.
In this case it is suggested that you place small round feet (included in
a plastic bag in the box in which the telephone was packed) on each
corner of the bottom of the telephone housing.
1. Turn the telephone face down on a flat surface.
2. Snap one end of the line cord into the "LINE" jack on the back of the
telephone (shown as 3 in Figure 5).
3. Thread the line cord through the routing channel leading to the top of
the desktop stand (2 in the figure above). Make sure that the cord is
LINE
6
5
4
19
1
2
3