Table of Contents
Advertisement
Plug one end of the coiled handset cord into the handset
6
jack on the side of the telephone.
Plug the other end of the handset cord into the handset.
7
Hang up the handset.
8
Plug the free end of the line cord into a modular wall jack.
9
Lift the handset and listen for dial tone.
10
Set the Ringer Volume Control switch to the setting you
11
want.
WALL INSTALLATION
Use the following directions to mount the telephone on a
standard wallphone jack with mounting studs.
Note: For wall installation, do NOT unbundle the line cord
packaged with the telephone; that is, leave the line cord in its
coiled position.
You must reverse the handset tab (which holds the
1
handset when you hang up). See Figure 4.
Hold down the switchhook and slide the handset tab up
and out of its slot.
Turn the tab so that the curved end is facing up.
Insert the tab back into its slot.
a. Handset
retainer
in place
c. Reposition
handset
retainer
down
Figure 5. Reversing the Handset Hook
Turn the telephone upside down so that you can see the
2
bottom of the telephone.
Remove the mounting base by sliding the base to the left
3
until it is free of the telephone. See Figure 4.
Turn the base so the larger end is down.
4
Plug one end of the line cord into the line jack on the
5
bottom of the telephone. (Keep the cord bundle in the
cavity on the lower housing.) Leave the other end of the
cord unattached for later use.
Note: You may prefer to use an 8-inch line cord rather
than the 7-foot cord provided with the telephone. If you
use the 7-foot cord, you will need to place it into the back
of the telephone in its original coiled position.
b. Press to release
and then remove
handset retainer
d. Replace handset
retainer
(up
position)
(down
position)
6
Advertisement
Table of Contents
