Table of Contents
Advertisement
—— INSTALLATION ——
TABLE/DESK INSTALLATION
Use the 7-foot straight line cord that came with your
telephone to connect the telephone to a modular jack.
!
WARNING:
Do not plug the handset cord into the line jack or the data
jack on your telephone since it could damage your handset
and the telephone.
1. Turn the telephone upside down so that you can see the
bottom of the telephone. See Figure 2.
Desktop
stand
Figure 2. The Bottom of the 6200 Series Telephones
2. Remove the desk stand by sliding it to the left until it is
free of the telephone base. See Figure 3.
Desktop
stand
Figure 3. Sliding the Base from the Bottom of the Set
3. Plug one end of the line cord into the line jack on the
bottom of the telephone.
4. Align the other end of the line cord so that it appears
through the slot at the top of the stand and reattach the
stand to the telephone by sliding the stand into the
appropriate tabs and to the right.
5. Turn the telephone right-side up and place it on your
desk or table.
6. Plug one end of the coiled handset cord into the handset
jack on the side of the telephone.
7. Plug the other end of the handset cord into the handset.
8. Hang up the handset.
9. Plug the free end of the line cord into a modular wall
jack.
10. Lift the handset and listen for dial tone.
11. Set the Ringer Volume Control switch to the setting you
want.
Line jack
4 holes for
wall mounting
Slide stand
to left and lift
WALL INSTALLATION
Use the following directions to mount the telephone on a
standard wallphone jack with mounting studs.
NOTE:
For wall installation, do NOT unbundle the line cord
packaged with the telephone; that is, leave it in its
coiled position.
1. You must reverse the handset tab (which holds the
handset when you hang up). See Figure 3.
• Hold down the switchhook and slide the handset tab
up and out of its slot.
• Turn the tab so that the curved end is facing up.
• Insert the tab back into its slot.
2. Turn the telephone upside down so that you can see the
bottom of the telephone.
a. Handset
b. Press to release
retainer
in place
c. Reposition
d. Replace handset
handset
(up
retainer
position)
down
(down
position)
Figure 3. Reversing the Handset Hook
3. Remove the mounting base by sliding the base to the
left until it is free of the telephone. See Figure 3.
4. Turn the base so the larger end is down.
5. Plug one end of the line cord into the line jack on the
bottom of the telephone. (Keep the cord bundle in the
cavity on the lower housing.) Leave the other end of the
cord unattached for later use.
NOTE:
You may prefer to use an 8-inch line cord rather than
the 7-foot cord provided with the telephone. If you
use the 7-foot cord, you will need to place it into the
back of the telephone in its original coiled position.
6. Slide the reversed base onto the telephone, to the right,
until it snaps into place.
Holes
for wall
mounting
Figure 4. Installing the Stand for Wall Mounting
7. Plug one end of the coiled handset cord into the handset
jack on the side of the telephone.
8. Plug the free end of the line cord into a modular wall
jack.
and then remove
handset retainer
retainer
Invert stand
Position stand
over 4 holes,
push stand down,
and slide to left
Advertisement
Table of Contents
