Removing Protective Film From Bumper; Installing Optional Wrap Board - Hussmann P/N 0420057_B Installation And Operation Manual

P/N 0420057_B
From the back of the case, hang the coil cover
from the top hooks, then position the drip tray in
the case with the drip tube connection to your
right. Hang drip tray on two back hooks and two
front hooks.
Front
Coil
Drip Tray Hooks
Connect installed copper drip tube to drip tray
using flexible connector supplied.
Ensure condensate flows freely from drip tray
through drip tube. Check the drip tube connec-
tion for leaks before stocking.
Drip Tray
Drip Tube
HUSSMANN CORPORATION, Bridgeton, MO 63044-2483 U.S.A.
Back
Coil
Cover
Drip Tray Hooks
Drip Tray
Connector
R
EMOVING PROTECTIVE FILM FROM
Remove protective film from bumper once
installation is complete.
Coil
Cover
Hooks

Installing Optional Wrap Board

MOA 0470438
1. Turn off power to case.
2. Determine location by positioning the wrap
board on the rear of the case between door
frames.
Rear View of Case - Location of Backups
2.668
TYP
19.327
TYP
7.562
12-Ft
8-Ft
6-Ft
4-Ft
Notes:
1. All dimensions given in inches.
2. For location of Backups on cases with add-on wedge, start measuring from
the square end of the case opposite the wedge end. Use corresponding case
size dimensions.
3. For location of Backups on 7-Ft cases (facing rear of case)
use 6-Ft case dimensions on the left and 8-Ft case dimensions on the right.
Backup
7.874 7.874
36.717 40.193
36.668
24.656
33.125
Service Merchandisers
1-9
B
UMPER
7.562
36.717
36.668
24.656