Table of Contents
Advertisement
P/N 0420057_B
CARE AND CLEANING
Long life and satisfactory performance of any
equipment is dependent upon the care it
receives. To ensure long life, proper sanitation
and minimum maintenance costs, these mer-
chandisers should be thoroughly cleaned, all
debris removed and the interiors washed down,
at least weekly.
Exterior Surfaces
The exterior surfaces must be cleaned with a
mild domestic detergent and warm water to
protect and maintain their attractive finish.
N
EVER USE ABRASIVE CLEANERS OR SCOURING
. D
NOT
PADS
O
USE AMMONIA BASED CLEANERS
.
ON ACRYLIC PARTS
Interior Surfaces
The interior surfaces may be cleaned with most
domestic detergents, ammonia based cleaners
and sanitizing solutions with no harm to the
surface. Removable parts are labeled R
.
FOR CLEANING
Removable stainless steel parts may be cleaned
and sanitized in dishwasher.
See next page for detailed direction.
NOTICE
Product will be degraded
and may spoil if allowed to sit
in a non-refrigerated area.
CAUTION
!
Do NOT use HOT water on COLD glass
surfaces. This can cause the glass to
shatter and could result in personal
injury. Allow glass fronts, ends, and
service doors to warm before applying
hot water.
HUSSMANN CORPORATION, Bridgeton, MO 63044-2483 U.S.A.
MAINTENANCE
Do Not Use:
•
Abrasive cleansers and scouring pads, as
these will mar the finish.
•
A hose on lighted shelves or submerge the
shelves in water.
•
Solvent, oil or acidic based cleaners on any
interior surfaces.
Do:
•
Remove the product and all loose debris to
avoid clogging the waste outlet.
•
Store product in a refrigerated area such as a
cooler. Remove only as much product as can
be taken to the cooler in a timely manner.
EMOVE
•
Turn off refrigeration, then disconnect
electrical power.
•
Thoroughly clean all surfaces with mild
detergent and water (105 to 140°F / 40 to
60°C). D
PRESSURE HOSES TO WASH THE INTERIOR
T
HESE WILL DESTROY THE MERCHANDISER
LINER AND SEALS CAUSING LEAKS AND POOR
PERFORMANCE
•
Lift or remove fan plenum for cleaning.
Hook chain in rear panel to secure plenum
during cleaning. Be sure to reposition the fan
plenum after cleaning merchandiser.
•
Take care to minimize direct contact between
fan motors and cleaning or rinse water.
•
Rinse with water, but do NOT flood. N
INTRODUCE WATER FASTER THAN THE WASTE
OUTLET CAN REMOVE IT
•
Allow merchandisers to dry before resuming
operation.
•
After cleaning is completed, turn on power
to the merchandiser.
WARNING
!
Prevent injury.
A
LWAYS SHUT POWER OFF
during cleaning process.
O NOT USE STEAM OR HIGH WATER
.
.
Service Merchandisers
5-1
.
'
S
EVER
Advertisement
Table of Contents
