Table of Contents
Advertisement
P/N 0420057_B
Installing Optional Scale Stand
MOA 0458960
1. Turn off power to case.
2. Determine location by positioning the scale
stand on the rear of the case between door
frames.
3. Using holes in scale stand bracket as a
template, mark hole locations on rear and top of
case.
4. Remove scale stand. Drill
pilot holes through metal liners at the marked
locations.
ETAL LINERS ARE LESS THAN 1
NOTE: M
--
THICK
DO NOT DRILL BEYOND METAL LINERS
5. Move top panel away from back of case.
Remove center rear door trim and remove LH
Upright wireway cover to allow routing of
receptacle harness.
Screw - SM #8-18 x
Truss Head
(3 required)
3/4 Bushing
LH Upright
Wireway
Harness -
Receptacle
HUSSMANN CORPORATION, Bridgeton, MO 63044-2483 U.S.A.
1
/
-inch diameter
8
/
-
8
INCH
.
Insulation in this area to be notched
3
/
as needed for wire harness routing.
8
Connect after routing wiring through case.
Isolated Ground Sticker
(If required)
Convenience Outlet
Scale Stand Upright Cover
Screw - SM #8-18 x
3
(2 required)
Rear Door Center Trim
Install strain relief connector where
Communication Cable exits scale
stand assembly. Use plug button if
Communication Cable i not required.
Communication Cable
Route cable with 12-in.
outside the strain relief
/
Hex Head
8
connector in the scale stand
1-11
Screw - SM #8-18 x
3
/
8
Truss Head
Case Wireway
Service Merchandisers
Advertisement
Table of Contents
