Table of Contents
Advertisement
1-10
I
NSTALLATION
3. Align the assembly on the back of the case
as shown below.
4. Using holes in wrapping board bracket as a
template, mark hole locations on rear of case.
5. Remove wireway cover; make sure there
are no wires behind hole locations.
3
6. Drill
/
-inch (0.1875) diameter holes for
8
1
three
/
-20 thread cutting screws through stain-
4
less steel and structural members.
7. Securely fasten brackets to case.
8. Adjust wrapping board as needed. The attach
points for hinging brackets on wrapping board is
determined by which position the assembly is to
be mounted. Refer to figures for LH, RH or
Center mounting positions.
P/N 0420057_B
9. Replace wireway cover.
10. Restore power.
U.S. & Canada 1-800-922-1919 • Mexico 1-800-522-1900 • WWW.HUSSMANN.COM
8.969 for 36-in. Board
8.656 for 48-in. Board
REF
0.812
3.25
REF
Bottom View of Wrap Board Panel
Wrap Board Panel
Bracket - Adj
(2 required)
1
Screw -
/
-20 x 0.5-in.
4
Hex Head Zinc Plate
(2 required for each bracket)
Wrapping Board Assembly for Mounting to Left Hand Side of Case
(Facing Front of Case)
Wrap Board Panel
Bracket - Adj
(2 required)
1
Screw -
/
-20 x 0.5-in.
4
Hex Head Zinc Plate
(2 required for each bracket)
Wrapping Board Assembly for Mounting to Right Hand Side of Case
(Facing Front of Case)
Wrap Board Panel
Bracket - Adj
(2 required)
1
Screw -
/
-20 x 0.5-in.
4
Hex Head Zinc Plate
(2 required for each bracket)
Wrapping Board Assembly for Mounting to Center of 12-Ft Case
or Mounting in Positions Other Than Left, Right or Center of Case
(Facing Front of Case)
8.969 for 36-in. Board
8.656 for 48-in. Board
REF
0.812
0.125-in.
Diameter
Drill 6 additional holes 0.5-in. deep
if not already existing in wrapping board.
1
Screw - #8 x
/
2
PHIL AB SMS
(3 required for
each bracket)
1
Screw -
/
-20 x 0.75-in.
4
Flange Thread Cutting
(3 required for each bracket)
Bracket Spacer
(2 required)
Mounting Holes
1
Screw - #8 x
/
2
PHIL AB SMS
(3 required for
each bracket)
1
Screw -
/
-20 x 0.75-in.
4
Flange Thread Cutting
(3 required for each bracket)
Bracket Spacer
(2 required)
Mounting Holes
1
Screw - #8 x
/
2
PHIL AB SMS
(3 required for
each bracket)
1
Screw -
/
-20 x 0.75-in.
4
Flange Thread Cutting
(3 required for each bracket)
Bracket Spacer
(2 required)
Mounting Holes
Advertisement
Table of Contents
