eXact PipeCut 280E System Operating Instructions Manual page 15

Information
Blade
Check the condition of the blade. Replace
a bent, blunt, or otherwise damaged blade with
a new one. Using a blunt blade can overload the
pipe saw's electric motor. When you notice that
the blade is blunt, do not continue sawing with
it, as the blade may become so badly damaged
that it will not be worth sharpening. A blade in
suffi ciently good condition can be sharpened
a few times by a professional sharpening
company.
Gripper unit
Clean the gripper unit regularly with compressed
air. Lubricate the gripper's wheel axles (Fig. P/1)
and its joints (Fig. P/2). Also clean and lubricate
the gripper's trapezoidal screw (Fig. P/3) and
the two worm screws on it (Fig. P/4).
Blade guard
When you have sawn plastic pipes and then
intend to start sawing metal pipes always clean
the inside of the blade guards. Hot particles
derived from sawing metal will burn plastic
particles, which may release toxic smoke. Make
it a rule to clean the blade guard regularly, and
pay special attention to keep the moving blade
guard movement from becoming hampered.
Lubricate the axis of the moving blade guard
regularly.
Motor
Keep the motors cooling vents clean.
Plastic parts
Clean the plastic parts with a soft rag. Only use
mild detergents. Do not use solvents or other
strong detergents as they may damage the
plastic parts and paint surfaces.
Power cable
Check the condition of the power cable regularly.
A faulty power cable should always be replaced
at an approved service agency.
Correct use and regular servicing and cleaning
will ensure the continued operation of the pipe
saw.
Environment
Separate collection. This product
must not be disposed of with normal
household waste. When your Exact
PipeCut machine is worn out, do not
dispose of it with normal household
waste. This product must be recycled
separately. Separate recycling of used
products and packaging facilitate
recycling and recovery of materials. Reusing
of recycled materials helps prevent pollution of
environment. According to local regulations it
is possible to deliver household appliances to
municipal rubbish depositories or to the dealer
when buying a new product.
Guarantee
If the Exact PipeCut pipe saw becomes
unusable due to material or manufacturing faults
within 24 months of the date of purchase, we
will replace the damaged parts with new ones or
supply an entirely new or factory-reconditioned
pipe saw to replace the damaged one.
The guarantee is only valid if:
The guarantee card or a dated purchase receipt
is returned to the manufacturer or retailer.
The pipe saw has not been misused.
No attempt has been made by non-approved
persons to repair the saw.
The pipe saw has been used in accordance
with these operating, safety, and servicing
instructions.
The guarantee does not apply to blades or the
overload protection.
Due to continuous product development,
the information in this instruction book may
change. We do not give separate notifi cation
of changes.
15
english