Installing The Drivers Manually; Usb Print And Scan Drivers - Sagem MF 5482 Instruction Booklet

MF5482
14 Click on OK to finish the installation.
The Companion Suite Pro software is now installed on
your PC.
You can now connect your multifunction machine.
To connect the multifunction machine to the PC via USB,
refer to paragraph Adding a device connected via USB,
page 68.
To connect the multifunction machine to the PC via the
local network (LAN/WLAN), refer to paragraph Adding a
device connected to the network, page 68.
Printer and scanner driver name
Laser Pro LL2
Laser Pro LL2 network
Use the good printer driver according to your connection.

Installing the drivers manually

You can install the printer and scan drivers manually
without running any setup software.
This installation mode is only possible
Note
on Windows 2000, XP and Vista.

USB print and scan drivers

It is recommended to install the
Companion Suite Pro software first
and then to connect the USB cable
to your machine (see Installing the
full software package, page 63).
If you connect the USB cable before
installing the Companion Suite Pro
Important
software the recognition system
(plug and play) identifies
automatically that new hardware has
been added.
When you use this procedure, only
printing and scanning functions are
activated.
1 Locate your USB cable connectors and connect as
2 Power on your multifunction machine.
3 Click on L
Connection
USB
WLAN
4 Open the CD-ROM drive, insert the installation CD-
- 66 -
shown below on the picture.
The PC detects the device.
OCATE AND INSTALL DRIVER SOFTWARE
( ).
RECOMMENDED
The following screen appears.
ROM and close the drive.
The drivers are detected automatically.