Advanced Chipset Features - Advantech PCI-7030 User Manual

USB-ZIP
USB-CDROM
LAN
Disabled
! Gate A20 Option [Fast]
This item enables users to switch A20 control by port 92 or not.
! Typematic Rate Setting
This item enables users to set the two typematic controls items.
– Typematic Rate (Chars/Sec)
This item controls the speed at which the system registers auto-repeated key-
strokes. The eight settings are 6, 8, 10, 12, 15, 20, 24 and 30.
– Typematic Delay (Msec)
This item sets the keypress time delay before auto repeat begins.
Four delay rate options are 250, 500, 750 and 1000.
! Security Option [Setup]
System
Setup
! APIC Mode [Enabled]
This item allows users to enable of disable the "Advanced Programmable Inter-
rupt Controller". APIC is implemented in the motherboard and must be sup-
ported by the operating system, and it extends the number of IRQ's available.
3.2.4

Advanced Chipset Features

Note! This "Advanced Chipset Features" page controls configuration of the
board's chipset. This page is chipset dependent; screens may differ
somewhat depending on the chipset. It is strongly recommended that
only technical users make changes to the default settings.
PCI-7030 User Manual
Select boot device priority by USB-ZIP.
Select boot device priority by USB-CDROM.
Select boot device priority by LAN.
Disable this boot function.
System will not boot and refuses access to Setup page if the cor-
rect password is not entered at the prompt.
System will boot, but access to Setup requires password (default
value).
32