Table 2.1: Front Panel Lan Indicator Connector; Atx Feature Connector (Atxf1) - Advantech PCI-7030 User Manual

.

Table 2.1: Front Panel LAN indicator connector

LAN Mode
1000Mbps Link On
1000Mbps Active
1000Mbps Link Off
100Mbps Link On
100Mbps Active
100Mbps Link Off
10Mbps Link On
10Mbps Active Off
10Mbps Link Off
2.15

ATX Feature connector (ATXF1)

The PCI-7030 can support an advanced soft power switch function, if an ATX power
supply is used. To enable the soft power switch function:
1. Get the specially designed ATX-to-EBX power cable
2. Connect the 3-pin plug of the cable to ATXF1 (ATX feature connector).
3. Connect the power on/off button to JPF1(9-10)
Default value is set ATXF1 to short pin1-2.
Important Make sure that the ATX power supply can take at least a 10mA load on the
5V standby lead (5 VSB). If not, you may have difficulty powering on your system.
PCI-7030 User Manual
LED1
Green On
Green on
Off
Orange On
Orange On
Off
Off
Green
Off
20
LED2
On
Green Flashes
Off
Green On
Green Flashes
Off
Green On
Flashes
Off