2.1
Introduction
You can access most of the connectors from the top of the board as it is being
installed in the chassis. If you have a number of cards installed or have a packed
chassis, you may need to partially remove the card to make all the connections.
2.2
Front Panel Connectors (JFP1 & JFP2)
There are several external switches to monitor and control the PCI-7030.
2.3
IR Connector (JIR1)
This connector supports the optional wireless infrared transmitting and receiving
module. This module mounts on the system case. You must configure the setting
through BIOS setup.
PCI-7030 User Manual
14