Installing The Battery Pack - Datalogic Pegaso Quick Reference Manual

Datalogic recommends annual replacement of rechargeable battery
packs to ensure maximum performance.

Installing the Battery Pack

When you first remove the Pegaso from the box, you must charge
both the battery pack and the backup battery for a minimum of 4
hours.
The Pegaso's Battery and its cover are integrated — they do not come apart.
Complete the following instructions to install the battery pack:
1. Loosen the elastic handstrap by releasing it from the bottom of the unit
(refer to the PRG).
2. Orient the battery pack with the latch facing toward the top of the Pegaso
(refer to
Figure 2 on page 7
3. Replace the battery door by inserting the bottom tab into the unit, then
clicking the latch into place. If the battery pack is installed incorrectly, it
will not seat properly.
4. Replace the handstrap at the bottom of the unit.
Figure 2. Installing the Battery Pack
a
Quick Reference Guide
).
Battery Latch
(push in to release)
b
Powering the Pegaso
Battery Pack
Seat this
end first
7