Videotron EMG2926-Q10A User Manual page 75

Note: If you are configuring the EMG2926-Q10A from a computer connected to the
wireless LAN and you change the EMG2926-Q10A's SSID, channel or security
settings, you will lose your wireless connection when you press Apply to confirm.
You must then change the wireless settings of your computer to match the
EMG2926-Q10A's new settings.
Click Network > Wireless LAN 2.4G/5G to open the General screen.
Figure 46 Network > Wireless LAN 2.4G/5G > General
The following table describes the general wireless LAN labels on this screen.
Table 27 Network > Wireless LAN 2.4G/5G > General
LABEL DESCRIPTION
Wireless LAN Select Enable to activate the 2.4GHz and/or 5GHz wireless LAN. Select Disable to turn it
off.
You can enable or disable both 2.4GHz and 5GHz wireless LANs by using the WIFI button
located on the side panel of the EMG2926-Q10A.
Name (SSID) The SSID (Service Set IDentity) identifies the Service Set with which a wireless client is
associated. Enter a descriptive name (up to 32 printable characters found on a typical
English language keyboard) for the wireless LAN.
Hide SSID Select this check box to hide the SSID in the outgoing beacon frame so a station cannot
obtain the SSID through scanning using a site survey tool.
Channel Selection Set the operating frequency/channel depending on your particular region.
Select a channel from the drop-down list box. The options vary depending on the
frequency band and the country you are in.
Refer to the Connection Wizard chapter for more information on channels. This option is
only available if Auto Channel Selection is disabled.
Chapter 9 Wireless LAN
EMG2926-Q10A User's Guide
75