Status Screen In Easy Mode - Videotron EMG2926-Q10A User Manual

The following table describes the labels on this screen.
Table 16 Wireless Security: WPS
LABEL
Wireless Security
WPS
Register
Exit

4.5 Status Screen in Easy Mode

In the Network Map screen, click Status to view read-only information about the EMG2926-Q10A.
Figure 30 Status Screen in Easy Mode
The following table describes the labels on this screen.
Table 17 Status Screen in Easy Mode
ITEM
Name
Time
WAN IP
MAC Address
Chapter 4 Easy Mode
DESCRIPTION
Click this to go back to the Wireless Security screen.
Create a secure wireless network simply by pressing a button.
The EMG2926-Q10A scans for a WPS-enabled device within the range and performs
wireless security information synchronization.
Note: After you click the WPS button on this screen, you have to press a similar button in
the wireless station utility within 2 minutes. To add the second wireless station, you
have to press these buttons on both the EMG2926-Q10A and the wireless station
again after the first 2 minutes.
Create a secure wireless network simply by entering a wireless client's PIN (Personal
Identification Number) in the EMG2926-Q10A's interface and pushing this button.
Type the same PIN number generated in the wireless station's utility. Then click Register
to associate the two and perform the wireless security information synchronization.
Click Exit to close this screen.
DESCRIPTION
This is the name of the EMG2926-Q10A on the network.
This is the current system date and time.
The date is in YYYY:MM:DD (Year-Month-Day) format. The time is in HH:MM:SS
(Hour:Minutes:Seconds) format.
This is the IP address of the WAN port.
This is the MAC address of the EMG2926-Q10A.
EMG2926-Q10A User's Guide
39