Monitor Troubleshooting - Fujitsu FUTRO DC20-1 Operating Manual

Monitor troubleshooting

Monitor troubleshooting

In the event of a fault, please start by checking the following points. If the problem with the
image is still not eliminated, try checking the monitor on another computer.
If you cannot solve the problem, please contact our Service Desk.
Are you experiencing this problem?
No screen display
Power indicator does not light up
Message;
No network available
LED flashes yellow
Message: Reset necessary
LED is lit yellow
Picture position is not correct
Picture is wrongly adjusted
Picture faults (vertical lines)
Picture faults (horizontal lines, picture noise)
The screen becomes darker
20
Check the following points:
► Check that the monitor ON/OFF switch is
set to ON.
► Check that the monitor power cable is
correctly plugged in.
► Check that the LAN cable is plugged in at
both ends.
► Switch the device off and then switch it on
again.
The monitor recognises an undefined mode.
► Perform auto-adjustment of the monitor via
the OSD menu.
► Perform auto-adjustment of the monitor via
the OSD menu.
► Perform auto-adjustment of the monitor via
the OSD menu.
► Perform auto-adjustment of the monitor via
the OSD menu.
► Perform auto-adjustment of the monitor via
the OSD menu.
► Set the contrast and brightness correctly
using the OSD menu if the auto-adjustment
function does not give satisfactory results.
Fujitsu Technology Solutions